Electrical power UNITS FOR LIFT TABLE one
Common Description
This energy unit is made solely to the little lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit is extensively made use of in the industry of logistic devices like minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed from the solenoid valve together with the velocity controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is made exclusively for that medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the pace managed by the adjustable needle valve. Once the lift rises to a large positoin, but the energy provide is cut, the decreasing movement is managed through the manual override perform.
Power UNITS FOR LIFT TABLE 3
Common Description
This energy unit is intended exclusively to the massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve plus the pace managed by a pressure compensated movement handle valve.
Energy UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is built solely for your huge lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve and the speed managed by the adjustable needle valve. When the lift rises to a higher positoin, but the energy supply is reduce, the decreasing movement is managed from the manual override function.
Exclusive Notes
1. This energy unit is of 
S3 duty cycle, which might only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic components concerned just before set up of the electrical power unit.
3. Viscosity of your oil shoud be 15~46 cst,which must also be clean and no cost of impurities.N46 hydraulic oil is suggested.
four. Oil altering is required right after the first one hundred operation hrs,afterwards when every single 3000 hrs.
five. The electrical power unit shown is created to be mounted vertically.
