Observing a handful of principles for appropriate installation is vital for the trustworthy and right operation of your gearbox or gear motor.
The guidelines set out listed here are intended as being a preliminary guidebook to picking out gearbox or gear motor. For efficient and right installation, comply with the instructions offered from the set up, make use of the maintenances manual to the gearbox readily available from our sales division.
Following is a 
brief outline of installation rules:
a) Fastening:
Spot gearbox on the surface providing adequate rigidity. Mating surfaces ought to be machined and flat.
Mating surfaces need to be inside definite geometric tolerances (see guide). This really is in particular genuine of flange-mounted gearboxes with splined hollow shafts.
In applications that involve higher radial loads in the output end, flange mounting is proposed for some gearbox sizes as this mounting can make utilization of the double pilot diameters presented in these gearboxes.
Be certain the gearbox is appropriate for your essential mounting position.
Use screws of resistance class eight.8 and above to safe the gearbox. Torque up screws to your figures
indicated from the relevant tables.
With transmitted output torque better than or equal 70% from the indicated M2max torque, and with
regular motion reversals, use screws with minimal resistance 10.9.
Some gearbox sizes is usually fastened working with both screws or pins. Of pin seated within the frame the gearboxes be not less than one.five occasions pin diameter.
b) Connections
Safe the connection parts to gearbox input and output. Tend not to tap them with hammers or very similar resources.
To insert these elements, make use of the services screws and threaded holes provided over the shafts. You’ll want to clean off any grease or protects from your shafts before fitting any connection elements.
Fitting hydraulic motors.
Be careful the O ring concerning motor flange and gearbox input flange when assembling. Install the
hydraulic motor just before filling lube oil in to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit must be this kind of to guarantee that brake is released instants prior to gearbox begins and utilized soon after gearbox has stopped. Verify that stress during the hydraulic line for brake release is at zero anytime gearbox is stopped.
Route of rotation
Motors are linked towards the ideal electric or hydraulic circuit according to their direction of rotation.
When performing these connections, keep in mind that all gearboxes, no matter if during the in-line or proper angle layout, possess the same direction of rotation both at input and output. For extra specifics with the connection of electrical and hydraulic motors, see related sections on this catalogue.
