SMR Gearbox Set up
Satisfactory functionality depends on proper installation. lubrication and servicing. thus it is crucial that the instructions while in the set up and maintenance leaflet. provided with each gearbox. are followed thoroughly. a number of the crucial elements of belt and torque-arm set up are listed beneath.
one. Install pulley on gearbox input shaft as close to the reducer feasible, and mount reducer on driven shaft as shut to bearing as practical. failure to do this may lead to extra loads inside the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive with the belt pull at about 90° towards the center line among driven and input shafts. this will likely permit tensioning in the wedge belt drive with all the torque arm which should really preferably be in stress. if output hub runs anti-clockwise. torque arm needs to be positioned the right.
three. lnstall torque-arm fulcrum on a rigid support in order that the torque-arm will probably be at around correct angles towards the center line with the driven shaft as well as the torque arm situation bolt. ensure there exists enough take up while in the turnbuckle for belt tension adjustment.
Continue to keep shut.
Bell drive may be situated in any easy postion. if the torque arm should be to be used to tighten the belts, the drive needs to be at about tight angle towards the line concerning the input and output shafts.
Bell drive may very well be positioned to your right if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that proven during the illustration.
Torque arm and belt get up.
Torque arm may very well be mounted towards the proper if wanted.