TF Type Flanges
Model TF flanges are made from the same high-strength cast iron because the S flanges, but are intended to accommodate the global 
normal Taper Lock bushing for uncomplicated set up and removal
TF Type flanges allow for mounting the bushing on the front (hub) side in the flange
TF flanges can be found in sizes six via sixteen and can be employed with any kind of sleeve as pictured on page SF-5
TR Kind Flanges
TR flanges are comparable to your TF style, but let to the Taper Lock Bushing to be mounted and removed from
the reverse or serration side on the flange
The limited torque ratings on the Taper Lock Bushings allow TR flanges to only be utilised with EPDM or Neoprene sleeves
Distinctive bushing sizes are employed, so they’ve got different maximum bores than the TF flanges
Sizes 6 by way of 16 are available
Taper-Lock Bushings
The sector normal taper lock bushing can be a split style and design permitting a compression fit in the flange on the shaft without set screws
The very simple design and style helps make the installation and removal uncomplicated though the 8° taper grips tight and supplies superb concentricity
A Reduced level of inventory may be attained due to the many other energy transmission components that use Taper Lock Bushings such as: sheaves, sprockets, and pulleys
doesn’t offer the Taper-Lock Bushings themselves as these are widely offered from other manufacturers
